< Previous | Contents | Next >

Table of Contents


Section 1: Getting Started
1A Important Safety Information
1B Choosing a Good Location
1C Unpacking and Inspection
1D Installing the Roll Holders
1E Identifying the Parts
Interior
Back
Section 2: Media and Knives
2A Label and Roll Specifications
Label Sensing Methods
Roll specifications
2B Installing Digital Die-Cutting Label Stock
2C Installing Pre Die-Cut Label Stock
Pre Die-Cut Labels
2D Replacing the Digital Die-Cutting Knife holder
2E Replacing the Cutting Knife
2F Adjusting the Gap Sensor Position (Pre Die-Cut Labels Only)
Circular Labels
Section 3: Primera PrintHub (PC Only)
3A XY Cutter Settings – Cut Offsets, Knife Pressure and Stretch Factor
Adjusting Knife Pressure over time
3B Set the Gap Sensor Mode (Pre Die-Cut Labels Only)
3C Set the Label Feed / Cut Mode
Cutter Options
3D Adjusting Print Alignment
3E PrintHub Settings
3F PrintHub Printer Settings
3F PrintHub Printer Settings
Stock Feed Settings Advanced Catalyst
Section 4: Printing with BarTender
4A Using BarTender for Pre Die-Cut Printing
4B Using BarTender to add cut lines
4C Add Text, Barcodes and Graphics to a BarTender Label
4D Printing ONLY from Other Programs
4E Printer Driver Settings
Paper Size Orientation
Section 5: Troubleshooting
5A Solving Cut Alignment Offset Problems
5B Maintenance
Replacing the Cutter Wear Strip
Label Cut Dust
Cleaning the Printer
5C Cleaning the Output Cutter
Instructions
5D Technical Support
Technical DTM Print Support
Section 6: Technical Specifications FCC
< Previous | Contents | Next >

Copyright © 2001 -  DTM Print GmbH