Table of Contents
Section 1: Getting Started
Section 2: Hardware and Software Setup
Section 3: Primera PrintHub
3A Monitoring Ink Levels
3B Using the Cost Estimator
3C Set the Stock Sensor Mode
3D Set the Present or Cut Mode (Cutter Models Only)
3E Adjusting Print Alignment
3F Settings
Section 4: Using RFID (PC Only)
Section 5: Printing Using a PC
3B Using the Cost Estimator
3C Set the Stock Sensor Mode
3D Set the Present or Cut Mode (Cutter Models Only)
3E Adjusting Print Alignment
3F Settings
5A Using Bartender
5B Add Text, Barcodes and Graphics to a BarTender Label
5C Printing from Bartender
5D Printer Driver Settings (PC)
5E Printing from other Programs
Section 6: Printing from a Mac
5B Add Text, Barcodes and Graphics to a BarTender Label
5C Printing from Bartender
5D Printer Driver Settings (PC)
5E Printing from other Programs
6A Printer Utility Settings (Color Label 500 Utility)
6B Adjusting Print Alignment/Label Offsets
6C Set the Stock Sensor Mode
6D Set the Output Mode
6E Printing from Belight Swift Publisher
6B Adjusting Print Alignment/Label Offsets
6C Set the Stock Sensor Mode
6D Set the Output Mode
6E Printing from Belight Swift Publisher
6F Create a Custom Label Size/Printing from other Programs
6G Creating a Full Bleed Print
6H Printer Driver Settings
Section 7: Troubleshooting
6G Creating a Full Bleed Print
6H Printer Driver Settings
7A Solving Offset/Alignment Problems
7B Creating a Full Bleed Print
7C Clearing a Label Jam
7D Maintenance
7E Cleaning the Ink Cartridge
7F Technical Support
Section 8: Label and Roll Specifications
Section 9: Technical Specifications 7B Creating a Full Bleed Print
7C Clearing a Label Jam
7D Maintenance
7E Cleaning the Ink Cartridge
7F Technical Support