< Previous | Contents | Next >

Table of Contents


Section 1: Getting Started
1A Choosing a Good Location
1B Unpacking and Inspection
1C Installing the Roll Holders
1D Identifying the Parts
Interior
Back
Section 2: Media, Cartridges and Knives
2A Label and Roll Specifications
Pre Die-Cut Labels
Gap Sensor Adjustment
Roll specifications
2B Installing Pre Die-Cut Label Stock
2C Replacing Ink Cartridges
2D Adjusting the Gap Sensor Position (Pre Die-Cut Labels Only)
Circular Labels
Section 3: Primera PrintHub
3A Using the Cost Estimator
3B Set the Gap Sensor Mode
3C Set the Present/Cut Mode
Cutter Options
Present Options
3D Adjusting Print Alignment
3E PrintHub Settings
3F PrintHub Printer Settings
3G Multiple Printer Support
Section 4: Printing only to Pre Die-Cut labels
4A Create a label with NiceLabel
4A.1 Printing from NiceLabel
4B Using BarTender for Pre Die-Cut Printing
4C Add Text, Barcodes and Graphics to a BarTender Label
4D Printing from Other Programs
4E Creating a Full Bleed Print
4F Printer Driver Settings
Note on PC Settings:
Paper Size
Orientation
Print Quality
Color Matching
Ink Saturation
Rotate 180 Degrees
Enable Bi-di
Launch PrintHub
Details
Section 5: Printing from a Mac
5A Print Utility Settings (LX600 Config Utility)
To Find LX600 Config Utility:
5B Adjusting Print Alignment/Label Offsets
5C Set the Stock Sensor Mode
5D Set the Output Mode
Cut Options (Check Cutter Enabled)
Present Options (Uncheck Cutter Enabled)
5E Printing from Swift Publisher
5F Creating a Custom Page Size - Mac
5G Creating a Full Bleed Print – Mac
5H Printer Driver Settings
Printing from Swift Publisher
Printing from Preview:
Printing from Adobe Reader
Print Quality
Color Matching
Ink Saturation
Enable Bidi (Bidirectional) Printing
Section 6: Troubleshooting
6A Solving Print Alignment Problems
6B Maintenance
Cleaning the Printer
6C Cleaning the Cartridge – Poor Print Quality
6D Technical Support
Section 7: Technical Specifications
FCC
< Previous | Contents | Next >

Copyright © 2001 -  DTM Print GmbH